Configuration of a radio switch

Each radio switch can be configured individually.
Configuration of a radio switch

Status bar

1. Status bar
The status bar indicates
  • operating mode
  • last command
  • number of sent commands
  • number of errors occured when sending commands

Reset counter

2. Reset counter
This button zeros the counter for the errors.

Expand/collapse settings

3. Expand/collapse settings   This button expands/collapses the setting area.
The annunciator uses less space on the screen in collapsed state.

Switching behavior

4. Switching behavior
In  this area, you decide at which state the output is to switch on. The output switches off if the connected instrument shows a different state.

Hold time

5. Hold time
You can enter a minimum hold time after switching on to make sure that slower successive devices are able to recognize the switching state.

Channel selection

6. Channel selection  Selection of the transmission channel. The settings are valid for all radio switches on this channel.


7. Close     This button closes the window.
But it can be opened again, for instance by a double click in the selection tree. Only deleting the annunciator will erase it permanently.