Side display for vibration measurement

 
This panel appears each time vibration is measured.
Side display for vibration measurement
1

Header

1. Header
This field displays the name of the measuring run.
 Depending on the measuring run, this name can be:
  • Vibration measurement for Pilot survey
  • Vibration measurement for Initial run
  • Vibration measurement for Test run plane A
  • ...
2

State of execution

2. State of execution
This field informs about the execution state.
 The status can be:
  • This measurement is still to be executed.
  • This measurement is in progress.
  • This measurement was finished.
  • This measurement was discarded.
3

Discard measurement

 
3. Discard measurement
Click this button to discard the measurement.
After finishing vibration measurement the InnoBalancer will lock the start button so that no further measurement can be started. Before repeating the measurement you need to discard the previous measurement.
 
After discarding the measurement the button changes its design:
Click again to restore the discarded measurement if you have pressed the above button by mistake.