Measurement

 
While measuring, the InnoMeter HVM 6954 displays the vibration total value and a colored assessment.
Measurement
1

Measurement mode

1. Measurement mode  The selected measurement mode is shown once again.
2

Sensor placement

2. Sensor placement
The image shows the body's coordinate system. The sensor has to be mounted in a way that its axes are aligned accordingly resp. you have to select the axis accordingly in the sensor automatic.
3

Start/Stop

3. Start/Stop  This button starts resp. stops the measurement.
4

Status bar 1

4. Status bar 1  This status bar shows sensor and measuring channel.
5

Measuring values X/Y/Z

5. Measuring values X/Y/Z
The vibration value (weighted interval RMS value) for the axis is displayed here.
6

Status bar 2

6. Status bar 2
The second status bar shows:
7

Vibration total value

7. Vibration total value
The maximum of the values from the single axes is displayed as vibration total value.
8

Measurement duration

8. Measurement duration
The InnoMeter HVM 6954 displays elapsed and remaining measurement duration. The elapsed measurement duration counts with minus sign from start delay to 00:00:00. Afterwards, the elapsed measurement duration counts up to the aimed measuring time. The measurement is stopped when it reaches the aimed measuring time.
9

Remark

9. Remark
This remark informs about the current state.
10

Signal input

10. Signal input
At the signal input, you select the measuring channel and configure the measuring range. If you activated the sensor automatic the InnoMeter HVM 6954 selects the measuring channel automatically.