List of magnitudes

 
If you activate the list of magnitudes, the InnoAnalyzer detects the magnitudes from the frequency analyze and lists them up. Optionally, it also displays the measured values in the measurement chart.
 
List of magnitudes
1

Menu tabs

 
1. Menu tabs
 
By these tabs you can switch between setting options for the list of magnitudes and the presentation of the results. The appearance changes depending on the selected operation mode.
2

Operation mode

 
2. Operation mode
 
Three operation modes are available in the list of magnitudes:
  • switched off
  • normal
  • Half-width
The list of magnitudes is inactive.
Magnitudes and their respective frequencies are detected.
Magnitudes and their respective frequencies are detected, half-width and attenuation are identified.