Establish connection with the radio control unit

 
As soon as you generated an annunciator type radio switch, VibroMatrix tries to establish connection with the radio control unit automatically. To check the connection, double-click on the superordinated entry radio switch. A control window for the connection with the radio control unit opens.
As a condition for a successful connection you have to install the driver for the radio control unit FHZ 1000 PC and connect the radio control unit to the PC.
 
Establish connection with the radio control unit
1

Close

1. Close  This button closes the window.
But it can be opened again, e.g. by a double click in the selection tree.
2

Connection chart

 
The connection status between VibroMatrix and the radio control center is shown in a connection chart.
 
2. Connection chart
Unconnected status
Connected status
3

Establish connection

 
3. Establish connection
By clicking this button you connect VibroMatrix to the radio control center. You can see whether a connection has been established or not in the connection chart and in the journal.
4

Journal

 
4. Journal 
The connection attempts to the radio control center and the result are listed up here as well as entries for switching processes.
5

Close

 
5. Close   This button closes the window.
But it can be opened again, e.g. by a double click in the selection tree.