Establish connection with ADAM network

 
VibroMatrix always tries to establish connection with the ADAM network automatically. By double-clicking on the annunciator type Digital output in the selection tree, you open the settings for the ADAM network to check the connection.
 
As a condition for a successful connection you have to install the driver for the converter ADAM-4561 and connect the converter ADAM-4561 with the PC. If you want VibroMatrix to detect an ADAM output module, you have to supply it and wire it with the converter ADAM-4561 (see design).
 
As long as there is no connection, the settings are displayed as follows:
 
Establish connection with ADAM network
1

Close

 
1. Close  This button closes the window.
But it can be opened again, e.g. by a double click in the selection tree.
2

Connection chart

 
The connection status between VibroMatrix and the ADAM network is shown in a connection chart.
 
2. Connection chart
Unconnected status
Connected status
3

Connect VibroMatrix  with ADAM network

 
3. Connect VibroMatrix  with ADAM network
By clicking this button you connect VibroMatrix to the ADAM network. You can see whether a connection has been established or not in the connection chart and in the journal.
4

Journal

 
4. Journal 
 
The connection attempts to the ADAM network and the result are listed up here as well as entries for switching processes.
5

Close

 
5. Close This button closes the window.
But it can be opened again, e.g. by a double click in the selection tree.