Configuration options for the measurement mode

 
Configuration options for the measurement mode
1

Detailed name of the measurement mode

 
1. Detailed name of the measurement mode
2

Details

 
2. Details
For greater certainty concerning the selected measurement mode, the following details are displayed:
  •  assessment type
  •  position
  •  measurement location
  •  weighting filters for the different axes
  •  k factors
  •  assessment information
3

Aimed measuring time

 
3. Aimed measuring time The measurement is usually carried out for a limited time.
This duration can be entered here. However, it must not be below a certain minimum duration. By means of the ISO button, the minimum duration conforming to the standard is entered .
4

Integration time

 
4. Integration time The validity ot the measurement is monitored by means of a running RMS value.
You can enter the time frame (integration time) for forming this RMS value. By means of the ISO button, the time is set conforming to the standard.
5

ISO button

 
5. ISO button
By means of the ISO button you can set the following parameters conforming to the standard:
6

Daily exposure time

 
6. Daily exposure time
 
To be able to show a colored evaluation already during the measurement, VM_BODY requires a daily exposure time to which the measured values can be referred. The measurements are usually not carried out for the actual exposure time, but for a representative duration and then the measured values are extrapolated to the daily exposure time.
7

Delay to start

 
7. Delay to start
 
If you do not want the measurement to start right after pushing the start button, you can enter a delay here.